Effect of hybrid manufacturing (am-machining) on the residual stress and pitting corrosion resistance of 316L stainless steel
Nenhuma Miniatura disponível
Citações na Scopus
4
Tipo de produção
Artigo
Data
2022-10-05
Autores
Ed Claudio Bordinassi
MHURCHADHA, S. U.
SERIACOPI, V.
Sergio Delijaicov
LEBRÃO, S. M. G.
THOMAS, K.
BATALHA, K.
RAGHAVENDRA, R.
MHURCHADHA, S. U.
SERIACOPI, V.
Sergio Delijaicov
LEBRÃO, S. M. G.
THOMAS, K.
BATALHA, K.
RAGHAVENDRA, R.
Orientador
Periódico
Journal of the Brazilian Society of Mechanical Sciences and Engineering
Título da Revista
ISSN da Revista
Título de Volume
Citação
BORDINASSI, E. C.; MHURCHADHA, S. U.; SERIACOPI, V.; DELIJACOV, S.; LEBRÃO, S. M. G.; THOMAS, K.; BATALHA, K.; RAGHAVENDRA, R. Effect of hybrid manufacturing (am-machining) on the residual stress and pitting corrosion resistance of 316L stainless steel. Journal of the Brazilian Society of Mechanical Sciences and Engineering, v, 44, n. 10, oct. 2022.
Texto completo (DOI)
Palavras-chave
Resumo
© 2022, The Author(s), under exclusive licence to The Brazilian Society of Mechanical Sciences and Engineering.The use of additive manufacturing (AM) has grown exponentially in recent years and has many advantages, including feasibility, over other conventional processes in many current applications. The use of a second process, for example, machining, improves the surface finish and in this case, the use of two processes is known as hybrid manufacturing. Heat treatments are often performed on parts generated by the AM process, mainly to relieve the residual stresses generated, but for some materials, this can decrease the pitting corrosion resistance of the parts. The objective of this study is to analyze the effect of hybrid manufacturing (AM + machining) on residual stresses and pitting resistance corrosion, which can bring advantages to piece properties without the use of heat treatment. 316L stainless steel parts are generated by direct laser metal sintering (DLMS), with subsequent milling using a complete factorial planning for the design of the experiments. The cutting speed, feed rate, cutting depth, use of the cutting fluid and laser power in the DLMS process are all varied. Residual stresses are measured by X-ray diffraction and the blind hole method, with polarization curves raised by a potentiostat. The results show that it is possible to reduce the residual surface stresses in the parts, even for compressive stresses, and to improve the pitting corrosion resistance, when compared to the part without milling, depending on the cutting parameters used.