Engenharia Mecânica
URI permanente desta comunidadehttps://repositorio.fei.edu.br/handle/FEI/23
Navegar
2 resultados
Resultados da Pesquisa
- The effect of process parameters and cutting tool shape on residual stress of SAE 52100 hard turned steel by high speed machining(2020-04-26) PASCHOALINOTO, N. W.; Ed Claudio Bordinassi; Roberto Bortolussi; Fabrizio Leonardi; Sergio DelijaicovThis study focused on determining the residual stress of SAE 52100 hard-turned steel. The objective was to evaluate and compare the effects of the cutting-edge geometry and cutting parameters (cutting speed, feed rate, and cutting depth) on the residual stresses of three different conventional inserts: S-WNGA08 0408S01020A 7025, T-WNGA08 0408T01020A 7025, and S-WNGA432S0330A 7025. Tests were performed on 60 samples of SAE 52100 hardened steel with an average hardness of 58.5 HRC. The circumferential residual stresses of the samples were measured by X-ray diffraction. A full factorial design of experiments with three factors and two levels each with two central points and a replicate was used for a statistical analysis. The most significant results were as follows: For all inserts, the measured residual stresses were compressive, which extended the tool lifespan. The residual stresses of the Type-S inserts were significantly influenced by the cutting speed and depth, and those of the Type-T insert were significantly influenced by the feed rate and cutting depth. In addition, the residual stresses of the insert 3 were more compressive than those of the other two types of inserts. In other words, residual stresses are more compressive for inserts with larger chamfer angles even as the principal residual stress profiles were all compressive. This work has also shown that it is possible to determine a significant statistical relationship between cutting forces and residual stresses, allowing force measurements to predict the residual stress without any information on process parameters.
- Microhardness and residual stress of dissimilar and thick aluminum plates AA7181-T7651 and AA7475-T7351 using bobbin, top, bottom, and double-sided FSW methods(2020-05-12) Sergio Delijaicov; RODRIGUES, M.; FARIAS, A.; NEVES, M. D.; Roberto Bortolussi; MIYAZAKI, M.; BRANDÃO, F.Friction stir welding (FSW) is a relatively new manufacturing process (invented in 1991 at the Welding Institute, UK) and more than 5000 scientific articles have been published in the past 10 years in indexed journals demonstrating the robustness of the research. However, further research is necessary to ensure safe use of the technique for structural components, particularly with reference to the aeronautics industry. Residual stresses and their consequences on the life of welded products must be fully understood, in addition to their correlations with other properties such as hardness, strength, and microstructure. This paper is a part of the research being conducted to evaluate the impact of four FSW techniques (bobbin, top-sided, bottom-sided, and doublesided) on the mechanical properties in dissimilar thick joints (12.7 mm) of aluminum alloys (AA7181-T7651 and AA7475- T7351) used in the aeronautics industry. The residual stresses were measured using the incremental blind hole technique and analyzed using the integral method. The longitudinal residual stresses were all positive, with values between 100 and 200 MPa in the stir zone, whereas the transverse ones were all negative, with values between 0 and − 100 MPa. It was possible to verify that the Bobbin process produced lower values of residual stresses and demonstrated better stability in its distribution compared to all the other FSW methods tested.