Engenharia Mecânica
URI permanente desta comunidadehttps://repositorio.fei.edu.br/handle/FEI/23
Navegar
2 resultados
Resultados da Pesquisa
- Superficial residual stress, microstructure, and efficiency in similar joints of AA2024-T3 and AA7475-T761 aluminum alloys formed by friction stir welding(2021-09-05) PERANDINI, J. P. B.; Ed Claudio Bordinassi; BATALHA, M. H. F.; CARUNCHIO, A. F.; Sergio Delijaicov© 2021, The Author(s), under exclusive licence to Springer-Verlag London Ltd., part of Springer Nature.Friction stir welding (FSW) represents a conceptually simple technique that consists of joining either similar or dissimilar solid-state materials through higher plastic deformation rates. FSW is an important technique in the aeronautical and aerospace industries, and its development is vital because of the significant difficulty in joining higher resistance AA 2000 and AA 7000 aluminum alloys with conventional techniques, like fusion welding, due to porosity and mechanical property losses. Thin sheets with a 1.6-mm nominal thickness of AA2024, heat treated to condition T3, and thin sheets with a 1.6-mm nominal thickness of AA7475, heat treated to condition T761, were used to investigate the influence of welding parameters under superficial residual stress and the efficiency of joints by FSW of AA2024-T3 and AA7475-T761 aluminum alloys. A central composite design (CCD) was used as a statistical model in this study (23 factorial points, six stellar points, two central points, and two replicas). Micrographic analysis showed that in the nugget zone of the AA7475-T761 alloy, there was hardness recovery. The fractography images showed that failures occurred mainly due to the joint line remnant defect, evidenced by the presence of cracks. The superficial residual stresses show a maximum value of 81 MPa at the advancing side in run 27 (hot welding) of AA2024-T3, whereas in AA7475-T761, a value of 57 MPa was found in the same run. Finally, tensile strength represents an efficiency of ~92% of the AA2024-T3 base metal value, while for AA7475-T761, this value was ~85%. From a component design perspective, the parameter window of this study is identified as interesting for its evaluation in the possible application in component manufacturing, due to the low values of superficial residual stresses found compared to those in previous work.
- CAF—a simplified approach to calculate springback in Al 7050 alloys(2017) Brandao F.M.; Delijaicov S.; Bortolussi R.© 2017, Springer-Verlag London.Aeronautical industries have looked for news fabrication processes to reduce the costs and the waste of the material during milling operations. One of these new processes is the creep age forming (CAF). The purpose of this work was based on springback analysis during the forming of single- and double-curved sheets of Al 7050 by the process of CAF. A simplified model based on a Norton power law was used in order to, alongside with a program of finite elements, allow the calculation of springback after the process. The experimental verification was carried out. Beside the springback results, other results were a decrease in the Young’s module of 11.5% in the creep aging temperature, in relation with ambient temperature during the CAF process and the variation of aluminum alloy’s yield stress during the process. The springback effect increased on the basis of aging time and then decreased due to intense aging of the alloy; an ideal time of 8 h is estimated for the Al 7050 alloy to carry out the CAF process. The research is limited to the use of the simplified model and its applicable results to Al 7050 alloys. Al 7050 is aligned with its vast use in the aeronautical industry, and the simplified model’s application may rapidly offer the necessary values of springback for the tooling project.