Engenharia de Materiais
URI permanente desta comunidadehttps://repositorio.fei.edu.br/handle/FEI/17
Navegar
2 resultados
Resultados da Pesquisa
- Styrene-assisted grafting of maleic anhydride onto polypropylene by reactive processing(2008-02-05) Sílvia Bettini; Ruvolo Filho A.C.The grafting of maleic anhydride (MA) onto polypropylene (PP) was performed in the presence of the electron-donating monomer styrene (ST) according to a central composite experimental design, in which the initial MA and ST concentrations were varied. The grafting of MA onto PP in the absence of ST was also performed. All reactions were carried out in the molten state in a Haake rheometer. The amount of reacted MA and the extent of degradation in PP were determined by means of Fourier transform infrared spectroscopy and melt flow index (MFI) measure-ments, respectively. The results showed that the presence of ST in the reactive processing caused a reduction in MFI and an increase in the level of reacted MA when the initial MA concentration equaled the initial ST concentration. An increase in the initial MA concentration presented distinct behavior that depended on the ST content. ©2007 Wiley Periodicals, Inc.
- Effect of process parameters and composition on mechanical, thermal, and morphological properties of polypropylene/sawdust composites(2008-05-15) Sílvia Bettini; Uliana A.T.; Holzschuh D.Polypropylene/sawdust composites have been prepared according to a statistical experimental design, with varying sawdust and compatibilizer (maleic anhydride grafted PP) concentrations. To investigate process conditions, composites were first extruded in a twin screw extruder coupled to a Haake torque rheometer, without degassing, and then reextruded in a Werner Pfleiderer twin screw extruder, with two degassing zones. Process conditions were analyzed according to statistical techniques. Effect of the variables on mechanical properties was assessed through flexural modulus, tensile strength, and percent elongation at break and morphology was assessed by scanning electron microscopy. Comparison between the extruded and reextruded compounds indicated the need to reduce moisture, prior to and during processing, as well as the need of effective mixing of the compounds. Sawdust concentration showed to be the variable which affected most all properties assessed. Increase in sawdust concentration resulted in increased composite stiffness. The presence of the compatibilizer caused a slight increase in tensile strength and reduction in percent elongation at break, indicating improved adhesion at the PP/ sawdust interface. The reprocessed compounds were also analyzed by differential scanning calorimetry. © 2008 Wiley Periodicals, Inc.