Engenharia de Materiais
URI permanente desta comunidadehttps://repositorio.fei.edu.br/handle/FEI/17
Navegar
2 resultados
Resultados da Pesquisa
- Reusing Surlyn® Ionomer Scraps in LDPE Blends: Mechanical and Thermal Properties(2023-01-05) BARBOSA, M. F.; Adriana Martinelli Catelli Souza© 2023 Universidade Federal de Sao Carlos. All rights reserved.This study aimed to evaluate the possibility of reusing industrial scraps of Surlyn® ionomer by obtaining blends with Low-Density Polyethylene (LDPE). Blends of LDPE and Surlyn® scraps were obtained by extrusion with compositions ranging from 25 to 75 wt% of the ionomer. Their melt flow index (MFI), morphology (SEM), mechanical (tensile, flexural, impact tests) and thermal properties (DSC, TGA, HDT tests) were analyzed. The morphology of the blends presented two phases, indicating the immiscibility of phases. Surlyn® incorporation promoted a decrease in the degree of crystallinity of LDPE and a slight increase in the thermal decomposition temperature. In addition, Surlyn® decreased the decomposition rate of LDPE. However, the decrease in the degree of crystallinity did not affect the mechanical properties of the blends. Incorporating ionomer in LDPE promoted an increase in tensile and flexural strength, tensile and flexural modulus and strain at break. Impact strength decreased with increasing ionomer concentration.
- Assessment of the Von Mises Stresses and Stress Triaxiality in Notches Using Modified Tensile Specimens(2023-05-26) PEREIRA, L. DOS S.; Gustavo Donato; MATTAR NETO, M.© 2023 Universidade Federal de Sao Carlos. All rights reserved.Complete understanding of the local stress triaxiality and stress concentration is essential to ensuring structural safety of several structures. A combination of mechanical tests with numerical simulations can be used to obtain this information. One way to study stress triaxiality is by modifying the standard tensile test geometry (ASTM E8) with a notch. Based on previous results from the literature, five notches were chosen: 10, 5, 3, 2, and 1 mm. These geometries were tested, and the results were numerically reproduced using the Abaqus/Explicit 2020 software. The models used were a non-linear model with the Gurson-Tvergaard-Needleman damage model to reproduce the failure. The numerical analyses allowed the assessment of the von Mises stress and stress triaxiality near the notch to compare with the standard smooth specimen. Two instants were considered as crack propagation onset; the instant of the maximum von Mises stress in the element at the center of the specimen, where the failure process begins; and the moment of maximum stress in the true stress x true strain curve. For the von Mises stress analysis, the difference between the curves was small. The stress triaxiality is a better variable to visualize the influences of the notch. When the strain is equal to a 0.07 (instant of the maximum force for the standard specimens), for the smaller notches (1 and 2 mm), there is a region where the effective plastic strain is zero. Consequently, the stress triaxiality is larger in this region than in the center. For the crack propagation onset instant, the plastic strain occurs along the whole transversal section. In this instant, the maximum value of stress triaxiality occurs in the center for all specimens. These results demonstrate that the stress triaxiality changes as the strain increases, i.e., varies with time.